6
Operation
Before using this equipment it must be cleaned and
dried thoroughly. Clean all surfaces before use. Failure
to clean surfaces before using the unit could cause food
contamination.
Always unplug the unit after every use and before
cleaning. Unplug the unit when not in operation.
•
Allow unit to cool completely before cleaning.
•
Clean main body with a clean dry cloth and mild cleaning solution.
•
Clean sealing wire and handle rubber cushion with clean dry cloth.
Always keep the sealing platform clean and of residual and spills.
WARNING:
•
DO NOT use wet cloth or cleaning solution on sealing wire
•
DO NOT immerse the device completely in water to clean.
The appliance should also NOT be cleaned with a power
washer.
NOTE:
Proper cleaning instructions must be followed; otherwise,
operation of the unit may be seriously impaired. Do not
wash parts in an automatic dishwasher.
WINCO authorized service personnel must perform any other servicing.
Cleaning & Maintenance
1. Set unit on a flat level surface and check for clearance above
the unit. Handle is normally up.
2. Plug power cord into receptacle.
3. Set seal time for 2 seconds, adjust the timer for more or less
seal time as required.
4. Place the bag on the sealing platform , and lower handle to
automatically seal. The indicator light will turn off when seal
time is completed. Wait 1-2 seconds of cooling time before
lifting the handle.
5. Inspect the seal, if seal appears damaged, reduce seal time as
required.
6. If the bag sticks to the handle rubber cushion, increase the
wait cooling time before lifting the handle.
7. Unplug power cord from the receptacle when unit is not in use.
Do not clean when plugged in - HOT!
Unplug the unit and wait for unit to cool before
cleaning.
CAUTION:
Safety
SAFETY PRECAUTIONS
Before installing and operating this equipment be sure
everyone involved in its operation are fully trained and
aware of all precautions. Accidents and problems can
result from a failure to follow fundamental rules and
precautions.
•
A WINCO® Approved Recommended Qualified Service Technician
should carry out repairs if necessary. Do not remove any
components or service panels on this product.
•
Allow the unit to cool down after use before dismantling for
cleaning;
the unit will be too hot to handle immediately
after use.
•
Before cleaning, disconnect power cord from the outlet.
•
Do not immerse unit in water or use hose to clean.
Ne jamais immerger l'appareil dans l'eau ni utilisez un jet
d'eau pour le nettoyer.
•
If the power cord is damaged, it must be replaced by a WINCO®
Approved Recommended Qualified Service Technician in order to
avoid a hazard.
