Winco RC-S301 Operating Instructions Manual Download Page 6

6

Operation

Preparation

1.  Measure rice with provided measuring cup. 
2.  Rinse rice in a separate bowl until water is relatively clear.
3.  Place rinsed rice into the inner pot and add water according level 

indicator. 

 

    

Example: To cook 10 cups of rice, add water to level indicator 10. 

DO NOT cook more than max 30 cups of rice.

4.  Place Rice Cooker/Warmer on a flat leveled surface.  

 

DO NOT incline or slant the unit, this will prevent inner 

pot from full contact with heating plate causing parts or 

elements to burn out.

5.  Wipe dry the outside of the pot before placing into Rice Cooker/

Warmer. A wet pot may cause a crackling noise while cooking and 

may damage the unit.

6.  Place inner pot into the Rice Cooker/Warmer. Ensure the pan is 

directly in contact with the heating plate by turning it slightly from 

right to left until it sits properly.

7.  Close outer lid until it clicks.
8.  Plug the unit into 120V power source. Press the switch down to 

initiate cooking. The "COOKING" light will illuminate.

9.  After the cooking cycle is complete, the "KEEP WARM" light will 

illuminate. Make sure to leave lid closed for 15 minutes. This allows 

the rice to rest properly and retain steam.  

 

 

It is not recommended to keep rice in the warming mode 

for more than 6 hours.

10. When serving rice, be sure to use a plastic or wooden utensils. 

Using metal utensils may cause damage to non-stick coating on 

inner pot.  

11. Unplug the Rice Cooker/Warmer when not in use. 

It is recommended to clean the inner pot before the first use. 

Only 

use soft cloth or sponge - anything more abrasive will damage 

the surface

. Do not use abrasive powder or steel wool for cleaning 

the lid or the inner pan. It will cause damage to the surface.

Burn Hazard.

When in operation, the 

appliance surfaces will be HOT!

 

Please take extreme caution.

Risque de brûlure.

En fonctionnement, les surfaces de 

l'appareil seront CHAUDES!

S'il vous plaît prendre une extrême 

prudence.

USE CAUTION WHEN 

TOUCHING THE UNIT.

Ne touchez pas le liquide chaud 

ou les surfaces de chauffage 

lorsque l’appareil chauffe ou en 

fonctionnement.

WARNING

AVERTISSEMENT

HOT

Safety Precautions

Before installing and operating this equipment be 

sure everyone involved in its operation are fully 

trained and aware of all precautions. Accidents 

and problems can result from a failure to follow 

fundamental rules and precautions.

• 

A WINCO® Approved Recommended Qualified Service Technician 

should carry out repairs if necessary. Do not remove any 

components or service panels on this product. 

• 

Before handling, allow the equipment to cool after use. 

• 

Before cleaning, switch off power and disconnect power cord 

from the outlet.

• 

Do not immerse unit in water or use hose to clean. 

Ne jamais immerger l'appareil dans l'eau ni utilisez un jet 

d'eau pour le nettoyer. 

• 

If the power cord is damaged, it must be replaced by a WINCO® 

Approved Recommended Qualified Service Technician in order to 

avoid a hazard.

THIS EQUIPMENT MUST ONLY BE SERVICED BY AN AUTHORIZED AGENT.

To maintain the appearance and increase the service 

life, clean the water boiler daily. 
Clean all surfaces before using the appliance. Also 

clean after each day’s operation; however, the unit 

may require more frequent cleaning, depending on 

the volume of production.

Cleaning, Care & Maintenance

• 

Switch power off and disconnect from the outlet before cleaning. 

• 

Unplug the unit when not in operation.

• 

Allow unit to cool before attempting to clean.

• 

The exterior of the unit may be cleaned by carefully wiping with a 

damp cloth.

• 

DO NOT

 immerse the unit in water. 

• 

DO NOT

 clean with a pressure washer.

• 

Grains of rice or other foreign matter must be removed to ensure 

full contact of inner pan with heating surface.

• 

Remove the inner pot and inner lid, dip them into lukewarm water 

or clean them with mild detergent and rinse completely; dry with 

soft cloth. 

• 

Do not use abrasive or harsh cleaners on non-stick inner pot.

• 

The non-stick coating may discolor after repeated uses, but till not 

affect the non-stick property.

Summary of Contents for RC-S301













Reviews: