7
TM
Service and Repair
There are no user-serviceable parts within this appliance.
To avoid serious injury or damage,
NeveR
attempt to repair the unit
yourself.
To initiate warranty service contact: [email protected]
or call: 973-295-3899.
DO NOT send unit to WINCO® without first contacting our customer
service department.
See "Limited Warranty" section on page 10 for details.
If your ACCELMIX
TM
blender does not operate, please check the following prior to placing a service call.
Safety
A WINCO® Approved Service Technician should carry out repairs if
necessary. Do not remove any components or service panels on this
product.
If the power cord is damaged, it must be replaced by a WINCO®
Approved Service Technician in order to avoid a hazard.
Troubleshooting
pRoblem
possIble cAuse
RecommeNded solutIoN
The unit is not turning on
Power supply
Check that the power supply cord is correctly
plugged in and outlet is working.
Breaker has blown
Reset breaker button on the rear base of the unit.
Container is not sitting on base properly Make sure container is secured to the base
correctly.
Power switch has not been turned on
Check that the unit is plugged in and turned on.
Plug/cord or external wiring is damaged
Call WINCO to make service arrangements through
their service provider network.
Internal wiring fault
The unit is vibrating too much
Unit is not on stable surface
Place the unit on a level surface or on top of a
vibration resistant surface such as a rubber mat.
Lid is not on properly
Adjust the lid so that if fits tightly and is centered
on the container.
Loose hardware
Tighten any loose screws, nuts or bolts.