8
How to remove all tags from safe:
1. Open the safe with either the key or a previously programmed RFiD tag
or key code. Locate the red program button. Press and hold the button for five
seconds to erase all tags from the safe. All five red LEDs will begin to blink in
sequence. (The safe does not allow individual tags to be removed. They must all
be erased at one time. The intended RFiD tags can then be reprogrammed back
into the safe with the instructions on previous pages.)
NOTE: To abort the erase procedure, press the center logo button on the lid of
the safe, or do not touch anything, and the erase procedure will automatically
abort after 10 seconds and return to normal operation. Test RFiD tags and the
key code to confirm they are operational.
2. To confirm erasing procedure, press and release the program button again. All five
LEDs will blink three times to visually confirm all RFiD tags have been removed.
All RFiD tags will no longer work until they are programmed back into the safe with
the instructions in the “How to Program Your RFiD Tags” section.
Closing the Safe
The safe has a latch closure sensor that will illuminate the LED in the keypad when
the lid is closed.
Green – Latch has fully closed .
Blinking Red – Latch has NOT fully closed .
Press lid down to fully close or re-open and check for interference.
Security Cable
This safe includes a security cable that can be looped around a stationary object.
With the safe lid open, feed the lug end through the loop end and place the lug end
of the cable into the security cable slot and close the lid.
CABLE
LOOP
LUG
