Winbond W91570DN Series, Instruction Manual

Page: 14 / 45

W91570DN SERIES
- 14 -
If OFF HOOK , HOLD1
(or HOLD2
), ON HOOK , HOLD2 is entered, then
the dialer stay at hold function.
b. If ON HOOK &
HFI
¡õ
, HOLD1 (or HOLD2 ), HOLD1 is entered, then
the dialer will be off-line.
If ON HOOK &
HFI
¡õ
, HOLD1
, (or HOLD2 ), HOLD2 is entered, then
the dialer stay at hold function.
4. The function timing diagram is shown in Figure 10(a), 10(b), 10(c).
Adjusting Time Setting
OFF HOOK (or ON HOOK &
HFI
¡õ
),
SET
RTC
¡õ
, HOUR , MIN ,
SET
RTC
¡õ
(or ON HOOK )
1. Only HOUR and MIN keys are valid in set RTC mode.
2. Hours and minutes count forward as long as the HOUR or MIN key is pressed.
3. The on/off function of SET
RTC
is toggled, and the dialer will go back to a previous state after the
toggle off SET
RTC
function.
4. If the dialing sequence D1, D2, ..., Dn (including flash and pause) has not finished, SET
RTC
(or
'RTC' key pressed) will be ignored.
RTC Display Mode
OFF HOOK (or ON HOOK &
HFI
¡õ
), RTC
1.The real time clock display mode can be toggled on and off by RTC key.
2. The icon display will not be changed when enter RTC display mode and set RTC mode.
Check Key
OFF HOOK (or ON HOOK & HFI
¡õ
), CHK , R/P (or OKR , SAVE , Mn
, ..., etc.)
The redial (or memory) content will be displayed on the LCD when either R/P or OKR
is keyed in.
Downloaded from Elcodis.com electronic components distributor