Winbond ISD-T360, User Manual

Page: 25 / 29

25 ISD
ISD-T360 Reference Design User’s Guide
THE RING SELECT
BUTTON
Press the RNG_SEL button to display the current ring setting. Press and hold
the RNG_SEL button, and the LED display will show one of the following mes-
sages:
[r2] — The answering machine responds after second ring.
[r4] — The answering machine responds after fourth ring.
[rA] — If there are previously recorded messages, the answer-
ing machine responds after the second ring. Otherwise it
responds after the fourth ring.
SETTING SEC
(SECURITY CODE)
SEC (Security Code) numbers must start with a “9”. Thus the code numbers
are “9ab” or “9xy” where the “ab” and “xy” are the user’s input numbers.
To set the SEC, press the CODE button until the LED display shows “CS” and
“ab”, alternately (current code number). By pressing the CHANGE button, the
machine will display the current SEC code. Increase the left digit by pressing
the BWD button and the right digit by pressing the FWD button. To confirm the
setting, press CODE within five seconds. The machine will display “9ab”. If the
CODE button is not pressed within five seconds, the answering machine will
return to idle with the SEC remaining unchanged.
OGM, RECORD AND
PLAYBACK
Record an OGM
(Out-Going
Message)
You must record the outgoing message prior to entering the Answer/An-
nounce mode. Otherwise, the machine will not record any Incoming Mes-
sages.
To record an OGM, press and hold the OGM button until the beeps sound.
The DAM will begin to record and the LED displays the elapsed time of the
OGM. When recording is finished, press the STOP button. The machine will
playback the OGM and return to idle state. Note that the recording will be
terminated if it exceeds 60 seconds in duration.
Playback an
OGM
To playback an OGM, press the OGM button once. Increase or decrease the
volume by pressing the VOL_UP or VOL_DN button, respectively. To halt the
playback, press the STOP button. If no OGM was previously recorded, the
DAM will beep twice and the LED will display “--”. After playback the DAM will
return to idle.
SETTING ANSWER ON/
OFF/ANNOUNCE ONLY
Setting
Answer On
Press the ON/OFF button until the voice prompt “Answer on” sounds and the
LED displays a 2-digit number, which represents the number of ICM (In-Com-
ing Messages). In this mode, the answering machine will record all incoming
calls until memory is full (maximum 50 calls).