6
7
Cautions:
• Use only fresh batteries of the required size and recommended type.
• Always remove old or weak batteries; batteries can leak chemicals that can destroy
electronic parts.
• If you do not plan to use the detector for a long time, remove the batteries.
• Dispose of old batteries promptly and properly.
• You can extend battery life by using earphones, which require less power than the
built-in speakers.
Headphones
You can connect a pair of headphones (not supplied) to the detector so you can
listen privately. Using earphones also saves battery power and makes it easier
to identify subtle changes in the sounds you hear, for better detection results. To
connect earphones to the detector, insert the earphone’s 3.5mm plug into the EAR
jack on the control panel.
Note: The detector’s internal speaker disconnects when you connect earphones.
Listening Safely
To protect your hearing, follow these guidelines when you use earphones.
• Set the volume to the lowest setting before you begin listening.
• After you begin listening, adjust the volume to a comfortable level.
• Do not listen at extremely high volume levels. Extended high volume listening can
lead to permanent hearing loss.
• Once you set the volume, do not increase it. Over time, your ears adapt to the
volume level, so a volume level that does not cause discomfort might still damage
your hearing.
Traffic Safety
DO NOT wear headphones while operating your detector near high-traffic areas.
Even though some earphones are designed to let you hear some outside sounds
when listening at normal volume levels, they still can present a traffic hazard.
Control Panel
LOW BAT
When indicator lights up, replace the battery immediately.
VOLUME/POWER
Rotate the control clockwise to power on the unit. Rotate it
fully counter clockwise to power off the unit.
SENS
Rotate the control clockwise to get higher sensitivity.
Rotating it counter clockwise to decrease it.
DISC
Rotate the control clockwise away from ALL METAL to
get DISC mode. The DISC mode comes with auto ground
balance. Rotate the control slowly and clockwise to
eliminate different trash objects.
Rotate the control counter clockwise to the end to get ALL
METAL mode. All METAL also comes with auto ground
balance. It’s used to find not only ferrous metal, but also
non-ferrous one
VIEW METER
When unit finds any metal target , the meter pointer swings
to the right.
HEADPHONES
3.5mm headphone jack for headphones.
HEADPHONES
(located behind
the control box)
VOLUME
/ POWER
DISC
LOW BATT
INDICATOR
VIEW METER &
POINTER
SENS
