WIN Enterprises IP-60690, User Manual, Page: 36 / 42

36
ACPI functions are normally activated by the BIOS. The choices: Enabled and Disabled.
ACPI Suspend Type:
This option specifies what technology must be used for the state of hibernation. The choices
are: S1 (POS) Power on Suspend; S3 (STR) Suspend to RAM; S1 & S3
Run VGABIOS if S3 Resume:
Power Management:
This category allows you to select the type (or degree) of power saving and is directly related
to the following modes: HDD Power Down, Doze Mode and Suspend Mode
•
Min. Saving: Minimum power management
•
Max. Saving: Maximum power management
•
User Define: Allows you to set each mode individually
Video Off Method:
This determines the manner in which the monitor is blanked. There are three choices:
•
V/H SYNC+Blank: This selection will cause the system to turn off the vertical and
horizontal synchronization port and write blanks to the video buffer.
•
Blank Screen: This option only writes blanks to the video buffer.
•
DPMS Support: Select this option if your monitor supports the Display Power
Management signaling (DPMS) standard of the Video Electronics Standard to select
video power management values.
Video Off In Suspend:
This determines the manner in which the monitor is blanked. The choices: Yes, No
Suspend Type:
MODEM Use IRQ:
This determines the IRQ in which the MODEM can use. The choices: 3, 4, 5, 7, 9, 10, 11 and
NA.
Suspend Mode:
After the selecting period of system inactivity, all devices except the CPU shut off. The choices
are 1~2 min, 2~3 min,….up to 1 hour.
Soft-Off by PWR-BTTN:
This function can turn the system off with the on/off button places the system in a very
low-power-usage state, with only enough circuitry receiving power to detect power button
activity or Resume by Ring activity. The choices are Delay 4 seconds and Instant-Off.
29
PNP/PCI Configuration
This setup is used to configure Plug “n” Play IRQ assignments and route PCI interrupts to
designated ISA interrupts.
Use the PNP/PCI Configuration Setup option as follows:
1. Choose “PNP/PCI Configuration Setup”from the main menu, the following screen
appears.