WIN Enterprises IP-60690, User Manual, Page: 34 / 42

34
Onboard FDC Controller:
Select Enabled if your system has a floppy disk controller (FDC) installed on the system board
and you wish to use it. If you install an add-in FDC or the system has no floppy drive, select
Disabled to this field.
Onboard Serial Port 1/2:
This feature allows you to manually select the I/O address and IRQ for the first and second
serial ports. If is recommended that you leave it as Auto so that the BIOS can select the best
settings for it. But if you need a particular I/O port or IRQ that’s been taken up by this serial
port, you can manually select an alternative I/O port or IRQ for it. You can also disable this
serial port if you do not need to use it. Doing so frees up the I/O port and IRQ used by this
serial port. Those resources can then be reallocated for other devices to use.
UART Mode Select:
Select an operating mode for the serial port, the choices are: Normal, IrDA, ASKIR.
RxD, TxD Active:
UR2 Duplex Mode:
In an Infrared port mode, this field appears. Full-duplex mode permits simultaneous
two-direction transmission. Half-duplex mode permits transmission in one direction only at a
time. Select the value required by the IR device connected to the IR port.
Onboard Parallel Port:
This feature allows you to select the I/O address and IRQ for the onboard parallel port. The
default I/O address of 378H and IRQ7 should work well in most cases. Unless you have a
problem with the parallel port, you should leave it at the default settings. The choices are:
378/IRQ7