The single element parts are now screwed
into the antenna head. Use screws M6*35
(M6x35 / lockwasher / plate / square tube /
big washer / nut).
A third hand will be very helpful. The screws
are always put from outside into the antenna
head, the nuts are in the gap.
Take care: the 3 elements on the ’hot end’ must have the big hole (12mm = 0.5in. diameter) on the right
side and the 3mm lower side of the element. The 3 elements on the ‘cold’ side must have the big hole
to the left side and the small hole upward.
hole to the right hole to the left.
When all square tubes are mounted, the plastic holders
must be put in place. Use self tapping screw 3.5*16.
Note: 1 in. = 25.4 mm
WiMo Antennen und Elektronik GmbH
Am Gäxwald 14, D-76863 Herxheim Tel. (07276) 96680 FAX: 966811
http://www.wimo.com e-mail: [email protected]
