https://www.XPOtool.com
Item 63003
Page 10
The Tool Experts
01 2022
-1
1. Place a full container of spraying material un-
derneath the suction tube
(a).
Secure the return
tube
(b)
into a waste container.
2. Turn the pressure control dial to maximum pres-
sure. Turn the
PRIME/SPRAY
knob to
PRIME.
3. Plug in the sprayer and move the
ON/OFF
switch to the
ON (l)
position.
The unit will begin to draw material up the
suction tube, into the pump, and out the re-
turn tube. Let the unit cycle long enough to
remove test fluid from the pump, or until
spray material is coming from the return
tube.
4. Switch the pump
OFF (O).
Remove the return tube
from the waste container and place it in its operating
position above the container of spraying material.
Purging and priming the spray hose
1. Unlock the spray gun and turn the
PRIME/SPRAY
knob to
PRIME.
The spray tip SHOULD NOT be attached
to your spray gun when purging your spray
hose.
2. Pull the trigger and aim the spray gun at the side wall
of a waste container.
If using oil-based materials, the
spray gun must be earthed while purging (see
warning below).
Keep hands clear from fluid stream. Ground the gun by
holding it against the edge of a metal container while
flushing. Failure to do so may lead to a static electric
discharge which may cause a fire.
3. While pulling the trigger, switch the pump
ON
(l),
AND
turn the
PRIME/SPRAY
knob to
SPRAY.
Hold the trigger until all air, water, or
solvent is purged from the spray hose and ma-
terial is flowing freely.
If the PRIME/SPRAY knob is still on
SPRAY, there will be high pressure in the
hose and spray gun until the PRIME/SPRAY
knob is turned to PRIME.
