Thermostat settings:
After the heater has been turned on and the room reached a comfortable temperature, slowly
turn the thermostat knob counterclockwise until the heater shuts off (a faint clicking noise
should be heard). By setting and leaving the thermostat like this, the device will automatically
maintain the current temperature. By further turning it counterclockwise towards the "low"
position, the temperature can be lowered. In order to raise the temperature simply turn the
knob clockwise towards the "high" position.
Turning the device off:
Turn the center dial to the "off" position before plugging or unplugging the heater. Always
make sure to unplug the device while it is not in use.
Fan mode:
Turn the power level control switch to the fan setting before turning the thermostat knob
clockwise in order to make the fan run continuously.
Safety Features
The device's power indicator lamp will be illuminated, if either the fan or the heater are turned
on.
The inbuilt overheating protection device will make sure to automatically turn off the device if
the heater grill is obstructed or the heater will grow too hot. Once the heater has been turned
off this way it needs to be reset by turning it off and unplugging. After waiting approximately 10
minutes in order for the device to cool down, the power cord can be reconnected and the
heater be restarted.
This product is further equipped with a tip-over-switch, which causes the heater to
automatically shut down if it tilts over. Simply place the device on an even surface without
obstructions and make sure it is in an upright position in order to restart the heating process.
Maintenance
Before cleaning the device make sure to unplug it and wait for the heater to cool down completely. A
washable filter is located at the air inlet and can be removed in case it should require cleaning. In case
said filter should appear to be dirty, simply remove it from the device after unplugging the same and
making sure that it had cooled down. The filter can be rinsed with warm water, but needs to have dried
completely before it can be reattached to the filter. The outside of the heater can further be cleaned
with a damp piece of cloth while the device is unplugged.
Do not use any detergents for this process and never immerge the heater in water as it is not only
going to destroy the device, but can also be dangerous. Once the frame has been cleaned, make sure
to let the device dry properly before putting it to use again.
Notes
Do not operate the heater without the grill being properly attached to the device and refrain from using
it, if it has malfunctioned or been damaged in any way. Do not take it apart by yourself and instead
consult a qualified electrician in case repairs are necessary.
The best way to store this heater is inside its original carton with the power cord being tied up in order
to prevent it from being damaged while it is stored away.
© by WilTec Wildanger Technik GmbH
Seite 11
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
