© by WilTec Wildanger Technik GmbH
Item +
Page 3
05 2022-1
Introduction
Thank you for choosing to purchase this quality product. To minimise the risk of injury, we ask you to
always take some basic safety precautions when using this product. Please read this operating manual
carefully and make sure that you understand it.
Keep these operation instructions in a safe place.
WARNING
:
Read all safety precautions and instructions.
Failure to obey the safety precautions and instructions
might cause an electric shock, a fire, and/or severe injuries.
Keep all safety precautions and instructions for future use.
Safety instructions
General safety instructions
•
ATTENTION
:
The use of this device is only allowed with a fault current protection switch
with a triggering nominal current up to 30
mA (according to VDE 0100
Article 702 and 738).
•
The device is not intended for use by persons (including children) with impaired or limited phys-
ical, sensory, and mental abilities, or lack of experience and/or real knowledge, unless they are
supervised by a person responsible for their safety or follow the instructions made by this person
on how to correctly use the device. Children should be supervised to ensure that they do not
play with the device.
•
Always use an earthed power supply with the correct voltage. The corresponding voltage value
is given on the nameplate. If there are doubts concerning the earthing of the power supply,
contact a qualified person for checking it. Never use a damaged power cable.
•
Do not open this device in a damp or wet area or with yourself being wet and protect it from
direct sunlight. Install the device in a safe place so that nobody can walk on the cables, fall over
them, and/or damage them. Make for sufficient cooling by ambient air and avoid any heat build-
up. Before cleaning the device, pull out the plug and only use a damp cloth for cleaning. Avoid
using cleaning agents and make sure that liquids cannot enter the device.
•
The inner parts of the device do not contain components requiring maintenance by the user.
Leave all maintenance, control, and repair works to a qualified person.
•
During operation, the unsoldering gun, hot air piston, and nozzle have temperatures between
200
℃
and 480
℃
. Therefore, personal injuries or material damage inside the work area might
happen in case the unsoldering station is not handled with care.
Obey the following principles when working with this device:
•
After opening the parcel, check if every individual part of the device is in good condition or if you
can detect visible damage caused by transport. If there are damages visible, do
not
operate the
device, but
immediately
contact your vendor.
•
Switch off the device and pull out the plug before moving it.
•
Avoid exposing parts of the device to too high a mechanical stress (shocks, pushes, etc.).
ATTENTION
:
•
Perform a visual inspection of the device before every use. Do not use the device if the safety
appliances are damaged or worn out. Never override safety regulations.
•
Only use the device accordingly to the intended purpose stated in this manual.
•
You are responsible for the safety of the working zone.
•
If the cable or plug is damaged due to external influences, the cable must not be repaired, but
must be replaced with a new one.
