Introduction
Thank you for purchasing this quality product.
To minimize the risk of injury we urge that our cli-
ents take some basic safety precautions when using this device. Please read the operation in-
structions carefully and make sure you have understood its content.
Keep these operation instructions safe.
General safety instructions
CAUTION:
The use of the device is only permitted with a residual current circuit breaker with a triggering rated
current of up to 30 mA (according to VDE 0100 parts 702 and 738).
This device is not intended to be used by persons (including children) with limited physical, sensory or
mental capabilities or lack of experience and/or knowledge, unless they are supervised by a person re-
sponsible for their safety receive instructions or have been instructed on how to use the device cor-
rectly. Children should be supervised to ensure that they do not play with the device.
During operation, the temperature of the soldering iron, hot air iron and nozzle is between 200
and
℃
480
. This could cause injury or damage to equipment in the work area if the soldering station is not
℃
handled carefully.
When working with the device, observe the following principles:
After opening the package, check whether each individual part of the device is in good
condition and whether there is any visible transport damage. If there is obvious damage, do
not
use the device and
immediately
contact your dealer!
Switch off the device and pull the power plug if you want to move the device.
Avoid subjecting parts of the device to increased mechanical stress (impact, etc.).
CAUTION:
Perform a visual inspection of the device before each use. Do not use the device if safety
devices are damaged or worn. Never override safety devices.
Only use the device according to the intended use specified in these operating instructions.
You are responsible for the safety in the work area.
If the cable or the plug is damaged due to external influences, the cable must not be repaired,
but replaced with a new one.
The voltage of 230 V AC indicated on the nameplate of the device must correspond to the ex-
isting mains voltage.
Never lift, transport or fasten the device by the power cord.
Make sure that the electrical plug connections are protected from flooding and moisture.
Before working on the device, pull out the mains plug.
Avoid exposing the device to direct water jets.
The operator is responsible for compliance with local safety and installation regulations. Con-
sult a qualified electrician if necessary.
If the device fails, repairs may only be carried out by a qualified electrician.
WARNING:
Read all safety instructions and warnings.
Failure to follow the safety instructions could result in
electric shock, fire and/or serious injury.
Keep all safety notices and instructions for future use.
© by WilTec Wildanger Technik GmbH
Item
Page 3
http://www.WilTec.de
http://www.aoyue.eu
03 2021
-1
