WilTec 62555, Operation Manual, Page: 5 / 9

© by WilTec Wildanger Technik GmbH Item 62555 Page 5
http://www.WilTec.de
http://www.aoyue.eu 08 2021 -1
http://www.teichtip.de
•
Always place the power cord so that it is behind the device and led away from it.
•
Store the device out of children’s reach.
•
During work, hold the device with both hands and make sure to have a safe and stable stand.
Before using the device
•
Check the spot where you will use the device. With the help of a cable finder, check if there are
covered electricity, gas, or water conducts.
•
Before plugging the plug in, make sure that the voltage given on the nameplate matches the
existing mains voltage.
Mounting and changing bits (Fig. 2)
The device is equipped with an SDS Plus fixing system.
•
Lubricate a bit with a light film of lubricating grease before mounting it.
•
Pull back and hold the fixing sleeve (see Fig. 2).
•
Push the dust-free bit all the way into the chuck and turn it. The bit is locked automatically.
•
Check the lock by pulling the bit.
Removing an SDS Plus bit (Fig. 3)
Pull back and hold the fixing sleeve
(A) to remove the bit.
Using the device
Switching it on and off (Fig. 1)
•
Switching the device in: Push the on/off switch (3).
•
Switching the device off: Shortly push the on/off switch (3) and let it got.
Fixing the handle (Fig. 4)
•
For safety reasons, you may only use the hammer drill with the handles fixed.
•
By turning the handle holder, you can adjust the handle so that you have a secure posture.
Untighten and turn the handle holder counter-clockwise. Then re-tighten the handle holder.
Speed regulation (Fig. 5)
Adjust the rotation speed and impact number by turning the control dial. On the dial, you will find the
indications “min.” (lowest possible speed) and “max.” (highest possible speed) as well as intermediate
values.
Dust collecting device (Abb. 7)
Place the dust collecting device over the drill before performing hammer-drill work over head.