WilTec 62534, Operation Manual, Page: 6 / 6

© by WilTec Wildanger Technik GmbH Item 62534 Page 6
http://www.WilTec.de
http://www.aoyue.eu 12 2021 -1
http://www.teichtip.de
Other instructions
•
Before mounting and using, check all components for completeness and operability. Refer to
the following chart to know the parts, names, and quantities (v.e. Fig.
1).
Name Qty. Name Qty.
Components of handle and lever 1 Winged nuts 2
Fixing rail 1 Pressing pieces (14 mm–32 mm) 6 (1 per size)
Modules 2 User’s manual 1
Pin shaft and parts of winged nut 2 Toolbox 1
•
Do not allow that pressing pieces fall down to avoid damage.
•
The pressing piece and notch of the module should agree with the pipe size to avoid that the
surface of the pipe be scratched.
•
In case the lever cannot retract normally when operated, the tension spring has lost elasticity.
Replace the spring.
•
To simplify introducing of type-2025 and -2653 pipes into the pressing piece, slightly adapt the
pipe by pressing it by hand when using the pressing piece.
•
In case the pressing piece does not retract to normal position when you pull the lever apart, tap
it slightly downwards by hand. However, do not use a hammer or other solid objects for tapping
to avoid that the surface of the pipe be scratched.
•
Regularly lubricate the frame.
Important Note:
Reproduction and any commercial use (of parts) of this operating manual, requires a written permission
of WilTec Wildanger Technik GmbH.