(Optional) Remote Control Instructions
Upper “ʌ” button – “Up” button – raises shutter
Middle “–” button – “Stop” button – stops motor
Lower “v” button – “Down” button – lowers shutter
The channel settings can be switched by utilising the “ʌ”, “–” and “v” buttons. Every channel capable of
controlling either a single or a cluster of motors. If all LEDs are illuminated or the channel “0” has been
chosen, the remote control switches into the cluster control mode. In this mode it is not possible to
align, reverse, add or remove codes.
Note:
The time interval in between operation of the buttons must not exceed 10 seconds as the input
will otherwise be reset.
Code Alignment
Attention!
The motor has previously undergone code alignment. The original memory will be over-
written and thereby become unavailable after another code alignment.
Code Addition
Note:
A maximum of 20 codes can be saved.
Transmitter A = Code aligned
Transmitter B = Code unaligned
© by WilTec Wildanger Technik GmbH
Artikel 62455-62460
Seite 9
http://www.WilTec.de
http://www.aoyue.eu
11 2020
-1
