Figure A
Figure B
Figure C
Application
The device is ready for use once the unpressurised vapour is released from the applicator
(4).
Now incise the wallpaper before then slowly guiding the applicator
(4)
over the same in order
to steam it.
Pay attention to the condition of the wall and the wallpaper in order to optimise the efficiency
of your work. (Thicker wallpapers might require you to wait 10–20 min before they can be re-
moved.)
Make sure to regularly check the water level.
In case of the tank requiring to be refilled, make sure to disconnect the plug and wait 2 min be-
fore then opening the screw cap
(2).
Maintenance
This product does not require any specific maintenance procedures and only has to be freed from re-
mains of wallpapers as well as other residue after having been used. Only clean the plastic parts of
the device using a soft and damp piece of fabric. Do not submerge the device in water or other liquids
and do not use chemical cleaning agents or oils.
Attention:
Maintenance of the electric parts of the wallpaper stripper should only be performed by
specifically trained personnel.
© by WilTec Wildanger Technik GmbH
Item 62283
Page 6
http://www.WilTec.de
http://www.aoyue.eu
03 2021
-1