◦
if the fruit shredder starts to vibrate abnormally or makes any unusual noise (check imme -
diately).
If the cutting mechanism strikes any foreign objects or if the fruit shredder should start making
unusual noise or vibration,
◦
inspect for damage;
◦
replace or repair any damaged parts;
◦
check for and tighten any loose parts.
Do
not
attempt to repair the fruit shredder unless you are competent to do so. Do not allow
processed material to build up in the discharge area; this may prevent proper discharge and
can result in kickback of material through the feed opening.
Electric safety
Connect the mains cable to a standard 230 V (50 Hz) electrical supply. A damaged plug must
be disposed of to avoid a possible shock hazard and should never be inserted into a 13A
socket elsewhere. Your fruit crusher is double insulated for safety and requires no earth con-
nection. The operating voltage is 230 V with a 50 Hz frequency.
Extension cable:
The type of cable used must be 2 core double insulated with a cross section
of 3 × 1.0 mm². In case of uncertainty, please consult an electrician.
Operation
With the machine standing on firm level ground, standing on a board if necessary, plug the
machine into the mains supply, via a residual current device (RCD).
Place a collecting container such as a barrel or a box below the outlet port to collect crushed
fruit. Then start the machine by pressing the ON/OFF to ON. When the machine is running at
full speed, proceed to feed material into the hopper.
DO NOT
force it!
IMPORTANT:
◦
Please start machine
FIRSTLY,
and feed fruit after machine starts running. It is very
IM-
PORTANT!
The cutter blades will pull the material into the machine.
◦
NEVER
push material into the hopper with your hands.
◦
The material must be of a size to easily enter the holes in the hopper.
◦
Should the machine become clogged and stop delivering chippings, switch it OFF immedi-
ately and disconnect the plug from the mains supply.
Using industrial quality gloves any material in the chute needs to be removed. Take great care
to avoid contact with the cutter blades and use a stick where necessary.
Ensure the cover is properly secured before plugging it to the mains supply or restarting the
machine again.
© by WilTec Wildanger Technik GmbH
Item 61903
Page 5
http://www.WilTec.de
http://www.aoyue.eu
02 2021
-1
