2. Now fill up with oil until the liquid is at “600”.
3. Shake the mixture well so that it mixes optimally, and then pour it into the device.
Refuelling
Only refuel the machine in adequately lit areas to avoid spilling fuel.
Refuelling must also not take place near open flames or sources of ignition, as this can ignite
fuel vapours, which can lead to explosions.
Never refuel the device while it is in operation and allow the engine to cool down before
adding fuel.
Follow these steps to refuel the device:
1. Make sure that the engine is switched off and the device has cooled down sufficiently. The
on/off switch must be in the “OFF” position.
2. Check the current level of fuel by carefully removing the fuel filler cap. To do this, turn it
counter-clockwise.
3. Top up with fuel if necessary. Make sure that the tank is only filled up to the neck, as the
fuel expands due to the changing temperature.
4. Carefully tighten the tank cap again in a clockwise direction.
5. Check that the fuel cap is properly seated and tightly closed.
6. Remove any fuel remaining from the tank.
Commissioning
First press the stop switch.
Then put the carburettor lever to the start position
to engage the throttle.
Next, press the injection button 6 times to ensure
that there is sufficient petrol in the petrol lines.
© by WilTec Wildanger Technik GmbH
Item 61494
Page 16
http://www.WilTec.de
http://www.aoyue.eu
03 2021
-1
