© by WilTec Wildanger Technik GmbH
Item 52015
Page 5
10 2021
-1
Open the quick clamp and remove the opposite nut and spring. Hold the lever and pull out the axle and
spring. Remove the complete axle, but make sure that the wheel stays in place.
Slide the connecting piece onto the axle. The bride end of the spring should point outwards and touche
the lever. The arched part of the connecting piece should point outwards, the hook of the washer towards
the hub.
Insert the end of the axle through the hub and the hook of the washer into the frame notch. Re-place
the spring (bride end pointing outwards!) onto the end of the axle and re-mount the nut.
Set the clamp to a right angle, tighten the nut by hand, and clamp the lever. Connect the trailer with the
connecting piece by using a locking stud.
Important Note:
Reproduction and any commercial use (of parts) of this operating manual, requires a written permission
of WilTec Wildanger Technik GmbH.
