8. Press
ENTER
, "a0 Line X/Y" is displayed on LED window, which means that a line
feature is constructed successfully.
Note:
(1)
In step 2, the message displayed is in Backward Annotation Mode, and the
displayed message will be "Probe point
n
" in Forward Annotation mode (
n
is a
number).
(2) In steps 3, 4 and 6, the showing message is of the a0 a3 and a7, and the message
displayed maybe different from this example.
Example 3:
Construct a distance feature from C1 and C2 showed in the follow illustration.
Operating steps:
1. Return normal monitor state;
2. Press
CIRCLE
to begin measure the first circle C1. Please refer to 5.3.
3. Repeat step 2 to measure C2.
4. Press
DIST
, LED then display "Probe Offset 02", means to wait you enter a feature.
5. Press
or , then "a0 Circle R/D" is showed, it is the last measured feature C2.
6. Press
ENTER
, then "
√
" is displayed at left of LED window, which means that the
feature is selected;
7. Repeat step 4 and step 5 to select C2.
8. Press
FINISH
to finish. The LED will show a message of "a0 Distance X/Y", it means
the distance feature has been constructed successfully.
Example 4:
It is showed in the follow illustration that L1 pass through the centers of C1,C2, C3 and
C4, and L2 pass through two points. We will construct the angle of these two lines.
Operating steps:
1. Refer to example 2, measure the line L1.
2. Refer to 5.2, measure feature L2.
3. Press
ANGLE
, then press any key
Except the
POINT
key
4. Press
or to select L1, L2.
5. Press
FINISH
to finish operating, if successfully, LED will display a message of
"a0 Angle <12…".
Manual WDC-300
31
Summary of Contents for WDC-300
Page 1: ...Manual WDC 300 COUNTER FOR WPP 300 ...
Page 54: ...W03 134 ...
