4
Need help?
www.WilsonElectronics.com
Tech Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm MST
The outside antenna must be installed
vertically on a metallic surface.
2. Run the outside antenna cable
into the car. The cable is strong
enough that it may be shut in most
vehicle doors without damaging the
cable. For a cleaner look, carefully
pull down the door seal, run the
cable under the seal, and push the
seal back into place. This method
reduces wear on the cable as the
door opens and closes.
3. Install the Low-Profile inside antenna.
• Identify a place on the right side
of the driver’s seat to mount the
inside antenna. The location
should be at least 18 inches from
where the cellular device will be
used.
• Install the inside antenna at the
same angle as the cell phone
when held in use or near the
laptop’s cellular data card to
maximize signal strength.
For a more professional look,
you can install the inside antenna
underneath a car seat cover or
upholstery.
• When you have tested the
functionality of your Mobile 4G
Signal Booster, mount the inside
antenna by peeling off the backing
of the Velcro
®
and attach it to your
selected location on the seat and
secure the inside antenna.
4. Place and connect the Mobile 4G
Signal Booster.
• Select a location for the Signal
Booster that is free from excessive
heat, direct sunlight and moisture
and that has proper ventilation.
Good locations include underneath
a seat or under the dashboard.
• Connect the wire from the outside
antenna to the port labeled
“outside antenna” on the Signal
Booster.
• Connect the wire from the inside
antenna to the port labeled “inside
antenna” on the Signal Booster.
• Plug the power adapter into
vehicle’s 12V DC power supply
and attach the cord to the side of
Power Booster labeled “Power.”
NOTE: Do NOT connect the power
to the Signal Booster until you
have connected both the inside
and outside antennas.
