11
Need help?
www.WilsonElectronics.com
Tech Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm MST
Lightning
Surge Protector
(sold separately)
To Outside
Antenna
To Signal Booster
Ground Wire
(not included)
!
RECOMMENDED: INSTALLING THE LIGHTNING SURGE PROTECTOR
(SOLD SEPARATELY)
INSTALL THE LIGHTNING SURGE PROTECTOR (LSP) CLOSE TO THE SIGNAL
BOOSTER. ATTACH THE CABLE FROM THE OUTSIDE ANTENNA TO THE
SURGE PROTECTOR.
ENSURE THE LSP IS PROPERLY GROUNDED
.
#859992-75 OHM MAY BE PURCHASED AT
WWW.WILSONELECTRONICS.COM
OR BY CALLING 800-204-4104.
Signal Booster Specifications
DB Pro 4G
Specifications
Model Number
460003
Antenna connectors
F-Female
Antenna impedance
50 ohms
Dimensions
6.5 x 4.5 x 1.75 inch
(16.5 x 11.4 x 4.4 cm)
Weight
1.28 lbs (0.580 kg)
Frequency
704-746 MHz, 776-787 MHz, 824-894 MHz, 1850-1995 MHz, 1710-1755/2110-2155 MHz
Power output for a single phone (uplink) dBm
Maximum Power
700 MHz
Band 17
700 MHz
Band 13
800 MHz
1900 MHz
1700/2100 MHz
22.5
24.2
24.4
22.6
24.1
Power output for a single received channel (downlink) dBm
Maximum Power
700 MHz
Band 17
700 MHz
Band 13
800 MHz
1900 MHz
1700/2100
MHz
4.7
4.5
6.9
10.4
2.4
Noise Figure (typical downlink/uplink)
5 dB nominal
Isolation
> 110 dB
Power Requirements
110-240 V AC, 50-60 Hz, 8 W
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without factory reprogramming or
disabling the hardware. The Signal Booster will amplify, but not alter the incoming and outgoing signals in order to increase coverage of authorized frequency
bands only. If the Signal Booster is not in use for five minutes, it will reduce gain until a signal is detected. If a detected signal is too high in a frequency band,
or if the Signal Booster detects and oscillation, the Signal Booster will automatically turn the power off on that band. For a detected oscillation the Signal
Booster will automatically resume normal operation after a minimum of 1 minute. After 5 (five) such restarts, any problematic bands are permanently shut
off until the Signal Booster has been manually restarted by momentarily removing the power from the Signal Booster. Noise power, gain, and linearity are
maintained by the Signal Booster’s microprocessor.
