1
2
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [email protected]. Mon.-Fri. Hours: 7 am to 6 pm MST.
Powering Up the RF Signal Detector
Ensure that the Outside Antenna cable or Rubber Antenna is connected to
1.
the RF Signal Detector and the connection is tight before powering up the RF
Signal Detector.
Plug the AC power supply or battery pack into the RF Signal Detector
2.
input
marked “6V DC” (carefully, to avoid damaging the center pin). Plug into surge
protected AC Power Strip.
Wide Band Directional
Antenna
Check inside coverage
before & after installation
of Signal Booster system.
Cell Tower
Finding Strongest Outdoor Signal
Checking Inside Coverage Area
RF Signal Detector
RF Signal Detector
Inside Panel Antenna
Frequency Mapping
RF SIGNAL DETECTOR
Power
BW
Select
BAND
Select
CH
Select
872.75
1.5 -98
NOTE:
Utilize the velcro included in this kit to secure Battery Pack to bottom
side of Signal Detector.
