4
INSTALLATION INSTRUCTIONS
WWW.WILBRAD.COM.AU
PASSWORD & FINGERPRINT
First, pull out the control panel, then touch the control panel to arouse the system, after the light is on and
then enter “*” input password (initial password is 1234) #, you will see “OK” light is on, then after a “Di” sound,
drawer automatically open.
(1)
First time unlock, users can press ”*1234#” to open it after the system wakes up
(2)
When the password has been set, users can enter his or her own password to open it (between 4 and 6 digits),
or add fictitious passwords before and after the password, finally, press ”#” to open it
(3)
When the password is correct: the product will make a ”Di” sound and its ”OK” green light will blink
for a second.
(4)
When the password is incorrect: the product will make three ”Di” sounds and its ”ERR” red light
will blink three times
(1)
First time unlock, users can unlock it with any fingerprint.
(2)
When the fingerprint has been registered, users can unlock it by placing their fingerprint on the
fingerprint reader.
(3)
When the fingerprint is correct: The product will make a ”Di” sound and its ”OK” green light will blink
for a second.
(4)
When the fingerprint is incorrect: The product will make a “Di” sound and its “ERR” red light will
blink three times
(1)
The top three registered users of the system are administrators, so they do not need to distinguish
between fingerprint unlocking and password unlocking.
(2)
If you want to enter your fingerprint, please press the RESET button and update the password before
adding user.
(3)
The factory administrator’s password is 1234. The product does not support the fictitious
password before setting password.
(4)
First you should press the RESET button and wait for the buzzer to make a short sound then enter
the administrator’s password. After completing the above steps, you will pass the verification. Secondly,
the product will sound “DO,RE” and the “OK” light will flash. Then you will enter the desired password twice
or press your fingerprint twice. (If the password is wrong, you can press ”*” to clear it, and then re-enter)
When verification fails: the product emits three ”Di” sound, the ”ERR” light will blink, and the system goes to
sleep. When registration of a new password of fingerprint is successful: the product makes a ”Di” sound and
the “OK” light will blink for a second, and the system goes to sleep. When registration of a new password or
fingerprint fails: the product makes three ”Di”sounds, the ”ERR” light will blink, and the system goes to sleep.
Opening Method
Password Unlocking
Fingerprint Unlocking
Add Users (Password modification and fingerprint entry)
Fingerprint sensor
