Installation and operating instructions Wilo-Varios PICO-STG
15
en
Manual restart
A
manual restart
is activated by pressing and holding
the lower operating button and unblocks the pump as
required (e.g. after long idle time in summer).
Sync function
The
sync function
is activated by simultaneously press
-
ing the upper and lower operating buttons.
The synchronisation function can be activated if the
pump curves of a pump to be replaced need to be repro
-
duced.
The pump curves are reproduced by reprogramming the
pump using straightforward LED coding. Information on
suitable replacement pumps and LED coding is available
in the Wilo replacement guide or in the Wilo Assistant
app.
4 Intended use
The high-efficiency circulators in the Wilo-Varios PICO-
STG series are exclusively designed for circulating fluids
in hot-water heating systems and similar systems with
constantly changing volume flows and/or in the primary
circuits of solar and geothermal systems.
Permitted fluids:
• Heating water according to VDI 2035
(CH: SWKI BT 102-01).
• Water-glycol mixtures* with a maximum of 50 % glycol.
* Glycol has a higher viscosity than water. If admixtures
of glycol are used, the pumping data of the pump must
be corrected to match the mixing ratio.
Intended use includes observing these instructions and
the specifications and markings on the pump.
NOTICE
Only introduce ready-to-use mixtures to the
system. The pump must not be used to mix fluid
in the system.