- 4 -
PRECAUTION BEFORE USING THE PUMP
5. Portable wet well installation.
• The pump can be installed at any location on the application site when carrying out portable
wet well installation.
Observe and adhere to the following points:
- Secure the pump against falling over and moving(creeping) during use.
- Secure the pressure hose to the hose connection.
-> Site is prepared.
-> Pressure hose to be used: Min. inside diameter 32mm
-> Hose clip to be used: 32 – 40mm inside diameter
-> Hose connection to be used: 32mm(with female thread)
-> Attach the hose connection.
Twist the hose connection into the pressure port as far as it will go.
-> Slide the hose clip over the pressure hose.
-> Slide the pressure hose onto the hose connection at the pressure port.
-> Secure the pressure hose to the hose connection using the hose clip.
-> Position the pump at the installation site.
CAUTION! Use a hard surface or underlay at the
installation site to prevent sinking on soft substrate.
-> Lay the pressure hose and fasten it in the appropriate
place(e.g. drainage).
CAUTION! If the pump is placed in a full chamber,
hold the pump at a slight angle when immersing.
This causes the air to escape from the pump!
-> Route the connection cable to the socket/power supply.
-> Pump is installed.
