Starting of the heater (Ignition)
1.
Fill the tank with clean fuel until the needle of the fuel gauge is on „F“ position.
2. Close the tank lid.
3. Connect the heater with an earthed socket.
On initial or repeated start you can possibly hear a metallic noise.
This is caused by the fuel pump which pushes air bubbles out of the fuel line.
The heater will start within a few seconds.
If the heater does not start, repeat the procedure and take care
that the tank is sufficiently filled. Check this on the fuel gauge.
The eclectrical components of the heater are protected by a fuse on
the control board.
In case the unit does not start at all, check first the fuse and replace it
if necessary.
Also check if the unit is connected with a correct socket.
Compare with values on the serial plate.
RH 35
1. Complete above three steps.
2.
Operating switch (20) on position „ON“. The control light is lightning
the heater is igniting.
Fig. 10
13 of 26
