WH-2400 SERIES
PATIENT CARE UNITS
INSTALLATION & OPERATION MANUAL
PAGE
10
© Rev.
2/2017
1.800.428.4065
TOLL FREE
| www.willoughby-ind.com
Step 6: Install the Solid Surface Lavatory Top to the Cabinet
1.) Install the drain assembly inside the lavatory.
2.) Apply a bead of silicone caulk around the outer top edge of the cabinet and between the
lavatory top and the wall.
3.) Set the lavatory top in place on the cabinet making sure the back is fl ush with the wall.
Clean up excess caulk around the countertop edge.
Step 5: Install the Toilet and Waste Connections
1.) Slide toilet into position over the fl oor Z-clip installed in Step 2.
2.) Connect the toilet to the fl oor/wall waste outlet with appropriate gasket. Be sure to square the
toilet assembly to the back wall.
3.) Level and support the toilet solidly at the four corners using shims, if needed
(shims supplied by installer).
4.) Secure the toilet in place with appropriate hardware.
NOTE: If the waste outlet is through the back, use a no-hub type connector
(available as an option).
5.) On WH-2400 models with a back waste connection, tighten the connector clamps at this time.
INSTALLATION INSTRUCTIONS (CONT.)
