Page 13
Rev. 1/2019
www.willoughby-ind.com
Installation & Operation Manual
Aquafount
®
180° Washfountain
WAF-5403 Series / WAF-5404 Series
Willoughby Industries, Inc.
TOLL FREE
(800) 428-4065
● LOCAL
(317) 875-0830
● FAX
(317) 875-0837
Parts supplied:
•
Complete Unit (Pre-assembled)
•
Note: Hardware for wall anchoring by others.
Note: Use anchors that are adequate for the type of wall: drywall, concrete, metal studs,
wood studs, etc.
Note: Refer to rough-in drawing for backplate mounting hole locations to achieve 34"
rim
height.
1�)
Measure and mark the vertical centerline of the washfountain on the wall. Mark a level line at the
height prescribed by the rough-in drawing for the pedestal backplate center hole. Drill a hole for
a wall anchor (supplied by others) at this height mark.
Make sure that the intended anchor locations will provide adequate backing to support the
installed washfountain. If adequate backing does not exist, install appropriate support backing or
relocate unit before proceeding with installation
(backing provided by others).
2�)
Mount the pedestal on the wall using a wall anchor through the backplate center hole and the
first drilled hole. DO NOT TIGHTEN THIS FIRST WALL ANCHOR ALL THE WAY, as you may
need to adjust the pedestal to ensure it is level�
3�)
Make sure the pedestal is level and plumb against the wall, then mark and drill holes for the rest
of the wall anchors as specified by the rough-in drawing.
4�) Ensure once more the pedestal is level, then secure it to the wall using the remaining anchors
(supplied by others). Make sure all wall anchors are tight and secure against the pedestal
backplate.
Note: Be sure backplate is level and plumb against the wall so that water in basin will
drain correctly once assembly is completed.
Installation Instructions
PEDESTAL BACKPLATE
PEDESTAL BACKPLATE
CENTER HOLE
VALVE MOUNTING TAB
WALL ANCHORS
(SUPPLIED BY OTHERS)
NOTE:
FOR CLARITY OF WALL ANCHOR MOUNTING LOCATIONS, ONLY
THE BACKPLATE PORTION OF THE PEDESTAL IS SHOWN.
Step 1: Pedestal Mounting
