6
IR T2 Infrared Transmitter Programmer’s Guide
Available Commands
When in Command Line Mode, the following commands can be used. Press Enter to execute any command.
COMMAND
FUNCTION
audio_minmax_reset
Reset CHA & CHB audio capture data
audio_minmax_cha
min and max of CHA audio since reset
audio_minmax_chb
min and max of CHB audio since reset
sleep_now
Put the IR T2 to sleep immediately, if there is no audio
wake_now
Wake up the IR T2 immediately, even without audio
mute_audio_input=on
Mute the audio (on reboot, the audio will not be muted)
mute_audio_input=off
Unmute the audio
ir_low_power_mode=0
Put the IR T2 in full power mode for stronger infrared coverage
ir_low_power_mode=1
Put the IR T2 in 1/2 power mode for less infrared coverage
rf_band_select=0
Change the broadcast channel(s) to 2.3/2.8 MHz IR
rf_band_select=1
Change the broadcast channel(s) to 3.3/3.8 MHz IR
restore_defaults
Reset all settings to the default
reboot_unit
Restart the IR T2
visible_leds=enable
Turn on the LED status indicator lights on the back of the unit
visible_leds=disable
Turn off all of the LED status indicator lights on the back of the unit
visible_leds=blink_5sec
Turn off and on all of the LED lights for 5 seconds
unique_id
Display the unique identifier for this IR T2 unit
When
help
is typed into the command prompt (CMD: ) the information below will be displayed: