PAGE 37 OF 98
NIGHT SCAN POWERLITE, POWERLITE XTREME, AND POWERLITE HDT
OPERATING INSTRUCTIONS
TP-4723701-U
MAY 2021
5.7 Electrical Installation
Refer to the wiring diagrams in the Appendix section for electrical connections. These diagrams
are also available at www.willburt.com. Be sure to follow the torque requirements shown on the
wiring diagram. See Figure 5-8 for wiring access panel. To electrically connect the mast system,
proceed as follows:
1. Remove the screws from the left cover of the base (as viewed from the back of the unit) and
remove the cover.
2. Run the Bulkhead Cable from the HHRC connected to the bulkhead or the PMRC Control
Cable into the base through the access panel. Run all power/data cables into the base
through the access panel.
Figure 5-8 Wiring Access Panel
Light Power
Grommet
DC Mast Power
Remote Control/Data
Ø Range 0.71-0.98 in
(18-25 mm)
Ø Range 0.39-0.55 in
(10-14 mm)
Ø Range 0.51-0.71
(13-18 mm)
Auxiliary Access
(if needed)
Ø1.75 inch hole
(44 mm)
Summary of Contents for Night Scan Powerlite
Page 2: ......
