Wilkes WEB2, User Manual, Page: 33 / 44

33
2. Enter 9 9 5. The SETUP key blinks twice.
3. Select a macro key (for example, F1 ) and
press it once.
4. Press the key sequence you want to program
into the macro. For example, to turn on your
TV and raise its volume, press the TV mode
key once, followed by pressing the VOL+ key
once.
NOTE:
You can program up to 15 key presses into one
macro.
5.
Press and hold SETUP until it blinks twice.
6. To add another macro, repeat steps 1
through 5, substituting the new key sequence
to be added in step 4.
NOTE:
Programming more than five macros on the
same macro key overwrites previous settings.
Clearing a Macro Key
1. On the remote control, press and hold SETUP
until it blinks twice.
2. Enter 9 9 5 . The SETUP key blinks twice.
3. Press the macro key you want to clear once.
4. Press and hold SETUP until the active mode
key blinks twice.
USING THE MASTER POWER KEY
The Wilkes Remote Control has a unique feature
that allows you to sequentially turn up to five of your
home entertainment devices on or off with a single
key press.
NOTE:
MASTER POWER (POWER) only works in the
STB mode. If it is not programmed, only the set-top
box will turn on or off. In any other mode, pressing
MASTER POWER (POWER) once will turn the select -
ed device on or off.
Programming the Master Power Key
1. On the remote control, press and hold SETUP
until the last-selected device key blinks twice.
2. Enter 9 9 5. The last-selected device key
blinks twice.
3. Press POWER once.
4. For the first device you want in the power
on sequence, press a device key (e.g., STB)
once. Then press POWER once. For the sec-
ond device in the power sequence, press its
key once (e.g, TV ). Then press POWER.
5. Repeat step 4 up to four more times to add
the second, third, fourth, and fifth device, as
desired.
6. To save the settings and exit the program:
a. Press STB once.
b . Press and hold SETUP until the STB key
blinks twice.
Using the Master Power Key
1.
After programming, point the remote control
at the devices. Press STB once.
2. Press POWER once to sequentially turn the
programmed home entertainment devices on
or off. You will see the devices turn on or off
according to the programmed sequence.
Clearing the Master Power Key
1. On the remote control, press and hold SETUP
until the last-selected device key blinks twice.
2. Enter 9 9 5 . The last-selected device key
blinks twice.
3. Press and release POWER.
4. Press and hold SETUP until the STB key
blinks twice.
RE-ASSIGNING DEVICE KEYS
The Wilkes Remote Control can be set up to control a
second device of an already-assigned type. For exam-
ple, to have the unit control a TV, a set-top box, and
two audio devices (for example, two audio receivers),
re-assign the unused VCR key to operate the second
audio device as follows:
NOTE:
VCR is preset at the factory to control an RCA
VCR. Performing the steps below will overwrite those
settings.