Wilkes WEB2, User Manual, Page: 32 / 44

32
key blinks twice.
2. Enter 9 9 3 . The last-selected device key will
blink twice.
3. Press VOL- once. The last-selected device key
will blink four times.
4. Repeat steps 1 through 3 for each device you
want volume to be unlocked.
Now, after you select a device that has volume un -
locked (e.g., STB ), pressing VOL+ , VOL- ,or MUTE , will
control only that device’s volume.
Unlocking All Volume Control
(Global Volume Unlock)
NOTE:
Performing these instructions will set indepen -
dent volume control for all programmed devices.
1.
On the remote control, press and hold SETUP
until the last-selected device key blinks twice.
2. Enter 9 9 3 . The last-selected device key will
blink twice.
3. Press VOL+ once. The last-selected device
key will blink four times.
Locking Volume Control To One Mode
(Global Volume Lock)
NOTE:
The audio mode’s volume controls are active
regardless of Volume Lock settings. However, if you
lock the volume controls to the AUD mode, you will
control the audio device’s volume in all other modes
(i.e., VCR, DVD, TV, or CBL) . This can be an advantage
if, for example, you always listen to home entertain -
ment devices through your receiver’s speakers.
1. On the remote control, press and hold SETUP
until the last-selected device key blinks twice.
2. Enter 9 9 3 . The last-selected device key will
blink twice.
3. Select a mode (e.g., TV or AUD ) which you
want to use to control the volume. The select -
ed device key will blink twice.
Now, when you press VOL+ , VOL- ,or MUTE, the
volume of the selected device (e.g., TV) is controlled
regardless of mode.
PROGRAMMING ID LOCK
The Wilkes Remote Control is locked at the factory to
operate your service provider’s set-top box. However,
if you have another brand or model of set-top box or
satellite service that you would like to control, then
you’ll need to perform the following steps to unlock
the ID Lock, enter a new manufacturer’s code, and
lock the ID Lock again.
1. Turn on the set-top box.
2. On the remote control, press STB once; it will
blink once. Then press and hold SETUP until
the STB key blinks twice.
3. Enter 9 8 2. The STB key will blink four times,
indicating ID Lock is unlocked.
4. Perform the instructions under “Programming
Device Control” to program device control for
the desired cable converter or satellite receiv-
er. When you are done, perform steps 5 and
6 on this page to again lock the ID Lock.
5. On the remote control, press STB once; it will
blink once. Then press and hold SETUP until
the STB key blinks twice.
6. Enter 9 8 2. The STB key will blink twice, indi -
cating ID Lock is again locked.
PROGRAMMING MACRO KEYS
The Wilkes Remote Control includes two macro keys
(located directly below the MUTE and LAST keys).
Macro keys allow you to set up key macros to activate
certain keys in a specific order. For example, you can
set up a key macro to change the channels on your
TV, raise or lower the volume, and start recording on
your VCR, all with the touch of one key. If you want
to change the macros stored in a previously-pro-
grammed macro key, you’ll need to clear the key first
(see “Clearing a Macro Key”).
Programming a Macro Key
1. On the Remote Control, press and hold SET-
UP until it blinks twice.