Connection for Difference Devices
1.
Work with a General IR Camera:
Since above installation is done, no more adjusting will be required. With the default setting (Internal Jumper
is set for
MASTER
, the snap stand of gooseneck IR sensor must be required snapping on the camera case and
the IR sensor head always face and be very closed to the IR light source of camera. It will always work with
your general IR scouting camera or CCTV system synchronously at night time.
2.
Work with a WildSpy IR Camera or any Device
equipped with an output for IR triggering
If you are using any WildSpy Cam Night Vision models, or in
some cases, you might already have a device equipped with an
output for triggering other IR booster. This booster can be able
to connect to the trigger source directly with an attached cable.
You can use the extension cable to connect the booster and the
end is plugged to the
IR-OUT
port of the IR device. You have
to refer the instruction manual of your IR device to sure the
TRIGGER source pin for the cable plug center to be POSITIVE.
Also, the input level from the source is between 3~6V. If the
connection is correct, booster will work with your IR device
synchronously.
In this case, the gooseneck adaptor will not be
required for installation. Before connection, the booster will be
required to change the trigger source for the
SLAVE/ CABLE
firstly. You have to open the inner panel by loosing 3 screws
