W-PA SIP Public Announcer - Admin Manual
W-PA SIP Public Announcer - Admin Manual
Page 3 of 7
7 - Speaker output interface: connect external speakers or microphones
8 - Ground screw: connect external parts with metal housing to this interface to prevent static electricity and other
interference caused the equipment to work abnormally
Rear panel
1 - Speaker interface: according to the device input voltage adaptive output maximum power; 4 speaker, POE /
8W, 12V / 10W, 18V / 20W, 24V / 30W. The greater the horn impedance, the smaller the output power.
Suggested wire diameter: 18AWG or larger diameter
2 - Headset interface: connect external headsets or active speakers
3 - LED interface: 5V output, connect an external LED, indicating the network, call and registration statuses
4 - Function key interface: connect switch components to this interface
5 - Microphone interface: it is recommended to use an electret condenser microphone (sensitivity: -38dB, bias
voltage: 2.2V) and connect it with a shielded cable to the grounding screw to improve anti-interference
6 - Switch input interface: connect emergency switches, door sensors and other switch components to this
interface
7 - Switch output interface: corresponds to the short-circuit input interface, allows to control electric locks, alarm
lights and other equipment
8 - Power input interface: 12
input, according to the input voltage, determine the maximum W-PA output
~24V 2A
power amplifier
Installation of W-PA SIP Public Announcer
Connecting W-PA
Use five or super five network cable to connect your W-PA to the network
Connect the cable to WAN (PoE) port
Provisioning of W-PA
Wildix supports different provisioning modes:
Note: a power adapter is optional and used for power supply of any external connected equipment.
