W-AIR Small Business Admin Guide
W-AIR Small Business Admin Guide
Page 8 of 12
9. LED of the Repeater should turn solid green in several seconds, if it fails (solid RED) please repeat the
steps after the reboot of the base station
Call Features
DND, Call forwarding, Paging, Call intrusion, Intercom
All the Call Features can be set up in WMS or Wildix Collaborations in User Settings, or otherwise, directly from
the handset, by dialing the Feature Codes of the system.
Feature Codes and Pre answer Services - Admin Guide
Ring tones
Ring tones set in Collaboration are not applied to W-AIR handsets. You can set ring tones via Dialplan "Set"
application.
Consult
Dialplan applications Admin Guide
Call transfer, hold, call swap, conference call
These operations can be performed directly from W-AIR handset, consult the guide
details.
W-AIR Handsets support only 2 calls/ channels, this means, when you have one active call and one call on hold,
you can only perform a transfer of the active call to the party which is on hold, or vice versa. You cannot transfer
a call to some third party, because no more channel can be opened.
Notes:
If you have any problems with registering Repeater(s), reset it by pressing the
button on the
Reset
back side for more than 2 seconds (LED turns solid RED and then GREEN with a double
pulsation). Start the registration procedure again by following the last three points above
Repeater should be placed on a distance not less than 10 meters from its Base station
For a good conversation and a correct handover between Bases and Repeaters the dBm value
should be between -75 and 0.
