W-AIR Network consists of one or more gateways that should belong to the same LAN. A
base station can be a part of a W-AIR Network only if is reachable by other base stations.
Note: In order to be able to configure a W-AIR network, it is necessary to have an NTP
server configured. To configure the gateway to use the NTP server of the PBX, select the
gateway and click “Edit”, then enter the PBX IP address into the line “NTP Server” and click
“Save”.
1. Go to menu
Devices
→
W-AIR Networks
→
“Add”
2. Enter the name Name for your W-AIR Network
3.
Select
the gateways from the list on the left and move them to the list on the right
Note: If you change the Pin Code in the field “Code” from the default one (“0000”),
Repeaters will not work, so it is recommended to keep the default Pin Code.
4.
Click “Save”
Note: The first devices becomes the Master of the network (
M)
. The gateways make Radio
sync with each other automatically to extend the work range if possible.
5. Go back to the
Devices Menu
, select your base/bases and press
Configure / Sync device
button
LEDs of the Base Stations (multicell)
• LED blinks purple when a base is rebooting
• LED blinks red when a base reports a configuration error
• LED remains solid blue if a base is configured and registered to the Wildix PBX
LEDs of the Base Stations SB
• LED blinks orange when a base is rebooting
• LED blinks red when a base reports a configuration error
• LED remains solid green if a base is configured and registered to the Wildix PBX
Wildix W-AIR System - Administrator’s Manual 3.80.x
11
