Wilderness Systems, 575 Mauldin Road, Suite 200, Greenville, SC 29607
Wilderness Systems, 575 Mauldin Road, Suite 200, Greenville, SC 29607
18
From the zero draft position you can lower the Helix PD into a stowed position. Disconnect the latches (A1) (A2) on each side
and lower the Helix PD (E) forward by hand to pivot it into the stowed position.
The Helix PD (E) can be completely removed from the kayak when it is in the zero draft or stowed position by removing the
quick release pin (A6) and lifting the Helix PD (E) from the mounting bracket (A).
Caution:
Always raise the Helix PD (E) to the zero draft position or stowed position when approaching the shore to avoid
impacts to the Helix PD (E).
Tip:
Look through the scupper and baffles (D) to help visually align the propeller.
11.2 Pedaling
With the Helix PD (E) fully deployed, and your feet on the pedals (H), adjust your seat until you are in a comfortable pedaling
position. Generally, this means that there is a slight bend in your extended leg when the pedals (H) are horizontal. When you
are comfortable, tighten your seat into position.
The Helix PD (E) can be pedaled in forward and reverse to maximize your performance.
Tip:
The Helix PD kayak utilizes the AirPro Max seating system. The Helix PD (E) is optimized for use from the high seat
position.
11.3 Deploying the Rudder.
The Helix PD (E) is best utilized with a rudder (B) for steering. Before you launch make sure that the rudder hold-down (B7) has
been disengaged from the rudder.
To lower the rudder, utilize the rudder deployment control line (B6) assembly that you installed. Pull the stern most control
fitting of the rudder deployment control line (B6) forward to deploy the rudder and then pull the opposite control fitting of the
rudder deployment control line (B6) to stow the rudder.
11.4 Using the Steering Control
Control your rudder (B) with the steering control (J). Push the steering control (J) handle forward to control the kayak to the
left and then pull the steering control (J) handle to the rear to control the kayak to the right. Position the steering control (J)
handle in the neutral middle position to steer straight.
There is a storage position for the steering control (J) handle for transit or if you want the handle in a low-profile, out of the
way position. To secure in the staging position, grip the steering control (J) handle from near the steering control (J) base, and
pull out and away from the kayak. The steering control (J) handle will disengage from the steering control (J) mounting base
by approximately ¼”. Pull the steering control (J) handle down towards the stern in a horizontal position and secure in place
with the bungee paddle park on the Helix PD.
Summary of Contents for Helix PD
Page 1: ...Helix PDTM Owner s Manual...