4
OUTFITTING
USING THE RUDDER SYSTEM
Some kayaks come with an optional factory rudder system
included. After market rudder systems are also available.
Please
contact your local dealer for any questions regarding setup or
installation, or visit WildernessSystems.com for video
instruction.
Once your rudder is installed, use the lift line (located on the
right side of the boat, towards the rear of the cockpit) to drop the
rudder into the water by pulling it forward.
To operate the rudder, use the footbrace pedals. To maintain a
straight position, both pedals should be even with each other. To
steer the kayak right, push the right pedal down similarly to a
gas pedal. To steer the kayak left, push the left pedal down.
ORBIX HATCH COVERS
Lever-release open and close.
RUBBER DOME HATCHES
To remove the covers, find the tab
and peel off. To replace the cover,
line up ends first and then sides.
Then hook it under the hatch rim
and press it on firmly the entire
way around. Sealed bulkheads, if
equipped, add flotation and dry
storage to the hatch area.
SLIDELOCK XL FOOTBRACES
The SlideLock Footbrace system is easy to
access from inside the boat. Find the black plastic
rod that is on the side of the cockpit extending
from the footbrace.Lift it up and slide forward or
back so your foot is resting comfortably on the
footpeg and there is a slight bend in your leg.
Release the rod to drop into position locking the
footbrace.
KEEPERS XL FOOTBRACES
The adjustment lever is located on the backside
of the footpedal. To adjust, squeeze the lever
and slide the footpeg to the desired location.
Release the lever to lock it in place.