5
5. Installation
Caution!
The heater can only operate in the position shown in figure 1. Installing
the device in other position or installing it without the water filter may
lead to the damage to the heating element and the loss of warranty. Do
not screw the hoses too much so as not to damage the thread. Do not
seal the stub pipes with the so-called oakum or teflon tape. Protect the
electronic system from getting wet.
1. Put the template to the place where the heater is to be installed. Then, mark the
places where the holes for rawlplugs and the hole for a supply cable will be drilled.
The supply cable can be connected to the heater in two different ways illustrated in
figure 3 and figure 4.
2. Screw the heater to the wall.
fig. 3
fig. 4
remove with a knife
screw the heater
to the wall
screw the heater
to the wall
hole for a supply
cable