5
| Switch Design
Wieland Electric GmbH | BA001106 (Rev. A) | 01/2017
9
5.4
Mounting and demounting on a DIN rail
Mounting
The installation on a standard DIN mounting rail is
possible. The DIN-rail kit is screwed on the industrial
switch when out of factory. If the DIN-rail kit is not
screwed on the industrial switch, please screw the
DIN-rail kit on the switch first.
For installing the device follow the steps described
beneath:
1.
Slightly tilt the lower part of the switch back-
wards, away from the DIN rail.
2.
Hang the device on the DIN rail.
3.
Push the device down and against the rail until it
clicks in place.
4.
Check if the device is sitting tight on the mount-
ing rail.
Demounting
or uninstalling the device follow the steps described
beneath:
1.
Switch off the power supply.
2.
Lightly push the switch down and tilt the lower
part of the switch away from the DIN-Rail.
3.
Pull the device upwards off the DIN-Rail.
Mounting
Demounting