Mounting, wiring and demounting
Wieland Electric GmbH | BA001269 | 09/2021 (Rev. A)
27
Protection
•
The power section supply is to be externally protected with a fuse, which corresponds to
the maximum current. This means max. 10 A is to be protected with a 10 A fuse (fast) re-
spectively by a line circuit breaker 10 A characteristics Z!
•
t is recommended to externally protect the electronic power supply for bus coupler and I/O
area with a 2 A fuse (fast) respectively by a line circuit breaker 2 A characteristics Z.
•
The electronic power supply for the I/O area of the power module PW 24 V / 5 V (order no.
83.036.0040.0) should also be externally protected with a 1 A fuse (fast) respectively by a
line circuit breaker 1 A characteristics Z.
State of the electronic power supply via LEDs
After PowerON of the
ricos
FLEX system the LEDs RUN respectively MF get on so far as the sum cur-
rent does not exceed 3 A. With a sum current greater than 3 A the LEDs may not be activated. Here
the power module with the order number 83.036.0030.0 is to be placed between the extension mod-
ules.
5.3.2
Wiring bus coupler
Terminal module terminals
Do not connect hazardous voltages!
If this is not explicitly stated in the corresponding module description, hazardous voltages are not
allowed to be connected to the corresponding terminal module!
With wiring the terminal modules, terminals with spring clamp technology are used for wiring. The
spring clamp technology allows quick and easy connection of your signal and supply lines. In con-
trast to screw terminal connections this type of connection is vibration proof.
Data
U
max
AC 240 V / DC 30 V
I
max
10 A
Cross-section
0.08 … 1.5 mm² (AWG 28 … 16)
wire strip length 1000 mm
Wiring procedure
1
Pin number at the connector
2
Opening for screwdriver
3
Connection hole for wire
Insert a suited screwdriver at an angel into the square opening as shown.
Press and hold the screwdriver in the opposite direction to open the contact spring.
Insert the stripped end of wire into the round opening. You can use wires with a cross section of
0.08 mm² up to 1.5 mm².
By removing the screwdriver, the wire is securely fixed via the spring contact to the terminal.
CAUTION
