101~150 choose
Flash
Color choose
NA
NA
151~200 Color change
Speed
Color change
NA
NA
201~255 Color fade
Speed
fade
NA
NA
DMX Connection Test
：
Use Three-Pin Connection cable to connect the each unit.Set up the same DMX
address and the units can work in synchronization.
Master Slave Mode
（
I
）
Auto Mode
Press MENU button until the display shows AUTO Mode and then undo the MENU button to enter Auto
Mode. Press menu button to choose different parameter interface, which is as the below chart shows.
Press UP or DOWN button to modify the corresponding parameter. Keep pressing these two buttons, you
can speed up or slow down.
Parameter Instruction
Spd XX(01~10): Choose running speed of the pre-set programs, ten different speed to choose. 01
refers to the quickest and 10 refer to the slowest..
Fad XX(01~10): Choose to run FADE effect in pre-set program. Ten in total. 01 refers to the quickest
and 10 refers to the slowest
（
II
）
Sound Mode
：
Press MENU button until the display shows SOUND Mode and then undo the MENU button to enter
SOUND Mode. Press UP or DOWN button to modify the corresponding parameter.
A u t m o d e
Spd XX
A u t m o d e
Fad XX
A u d m o d e
Fad XX
Parameter Instruction
Fad XX(00~10):
Choose to run FADE effect in pre-set program. Five in total. 01 refer to the quickest
and 05 refer to the slowest
。
Slave mode
：
The fixture can work in auto or sound mode in Master
z
Trouble-shooting
Trouble Reason
Trouble
Shooting
The fixture doesn’t
work
1.Check if the fixture is running under
rating voltage
2.Check if the fuse is burnt
1. Be sure that the fixture is running
under rating voltage
2.Change fuse with the same
specification
LED is dim
1. Check if the fixture is running
under rating voltage
1. Be sure that the fixture is running
under rating voltage
Sound Mode
doesn’t work
1.Check if the fixture is working in
sound mode
2.Check the sound sensitivity
1.Set up the sound mode
2.Increase the sensitivity
The fixture can not
receive the DMX
signal
1
．
Check if the DMX cables are
connected rightly
2
．
Check if the fixture is working in
DMX mode
1
．
Be sure that the DMX cables are
connected rightly
2
．
Set up DMX mode
Page 4 of 4
