Wido WD040110036, Manual, Page: 10 / 16

OPERATING INSTRUCTIONS
Note: Before using the tool, read the instruction manual carefully.
1. Intended use
The machine is intended for driving in and loosening screws.
2. Before using your tool
Your battery in power tool is uncharged and you must charge once before use. When you charge the
new battery or one which has not been used for long periods of time, your battery may not be fully
charged until you have performed several charge and discharge operations by charging & working with
your power tool. After this your battery performance will improve.
Warning: The charger and battery are specifically designed to work together so do not
attempt to use any other devices.
3. Battery charging
1) Be sure the supply is the same as the voltage given on the nameplate of the battery charger.
Connect battery charger plug into the charger jack on the handle of the power tool, then connect battery
charger to power source, and charging indicator on handle of the power tool is illuminated in red color,
charging has started (See Fig 1).
2) After charging 3-5 hours, unplug the charger from the power source and remove the charger plug
from the charger jack on handle of the power tool.
Note: A new battery or one that is completely exhausted should be charged for five hours. After normal
use, the battery should be fully charged in about three hours.
Warning: Do not operate power tool or charger near flammable liquids or in gaseous
or explosive atmospheres. Internal sparks can ignite fumes.
4. Reversing the rotational direction
1) This power tool has a reversing switch to change the direction of rotation. press the forward and
rotation control lever from the “ ”side for clockwise rotation or from the “ ” side for
rotation (See Fig 2).
2) When the forward and reverse rotation control lever is in the neutral position, the switch trigger
cannot be pulled.
Note:
• Always check the direction of rotation before operation.
• Use the reversing switch only after the power tool comes to a complete stop. Changing the direction of
rotation before the power tool stops may damage the tool.
• When not operating the power tool, always set the rotation control lever to the neutral position.
5. Switching on and off
To start your power tool, simply press the switch trigger and keep it pressed. To switch off the machine,
anticlockwise
10
3.6V CORDLESS SCREWDRIVER ENG
reverse