Wido WD012411400, Manual

Page: 12 / 16

1400W MIXER ENG
4. Always store your power tool in a dry place.
5. The motor employs carbon brushes which are consumable parts. Since an excessively worn carbon
brush results in motor trouble. To inspecting or replacing the carbon brushes, use a screwdriver to
remove the four screws on rear cover (See Fig 7). Take out the carbon brushes. If it becomes worn to or
near “wear limit” (See Fig 8), replacing the new ones, reinstall the holder cap firmly.
Note:
• Both carbon brushes should be replaced at the same time. Use only identical carbon brushes. Keep
the carbon brushes clean and free to slip in the holders.
• The brush holder caps must be tightened firmly when reinstall the brush holder cap into power tool.
6. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
TROUBLESHOOTING
1. If you see bigger sparks flashing in the ventilation slots than normal sparks, take out the carbon
brushes. If it becomes worn to or near “wear limit”, replace the new ones.
2. If your power tool will not operate, check the power at the mains plug, or check the carbon brushes.
3. If the mixer doesn’t work properly, check the mixing paddle, replace mixing paddle if worn.
4. If a fault can’t be rectified, return the power tool to an authorized dealer for repair.
ENVIRONMENT PROTECTION
Waste electrical products should not be disposed of with household waste. Please recycle
where facilities exist. Check with your Local Authority or retailer for recycling advice.
12