Wido WD010110350, User Safety And Operating Instructions

Page: 11 / 16

350W ELECTRIC DRILL ENG
8. Screwdriving operation
Place the point of the driver bit in the screw head and apply pressure to the power tool. Start the power
tool slowly and then increase the speed gradually. Release the switch trigger as soon as the clutch cuts
in (See Fig 5).
Note:
Make sure that the driver bit is inserted straight in the screw head , or the screw and /or bit
may be damaged.
WORKING HINTS FOR YOUR POWER TOOL
1 Drilling steel
Turn the torque adjustable ring so that the pointer points to the “ ” marking. HSS drill bits should
always be used for drilling steel.
2 Drilling wood
Turn the torque adjustable ring so that the pointer points to the “ ” marking. Wood drill bits should
always be used for drilling wood.
3 Screw driving
Always use the correct type of screwdriver bit. If screws are difficult to tighten, try applying a small
amount of washing liquid or soap as a lubricant.
4 Pilot holes
1) When drilling a large hole in tough material (i.e. steel), we recommend drilling a small pilot hole first
before using a large drill bit.
2) Before screwing larger, longer screws into hard materials, we recommend drilling a small pilot hole
with the core diameter of the thread to approx. 2/3 of the screw length.
5 Cool the motor
If your power tool becomes too hot, set the speed to maximum and run no load for 2-3 minutes to cool
the motor.
MAINTENANCE
Warning: Remove the plug from the socket before carrying out any adjustment, servicing
or maintenance.
1. Keep the power tool ventilation slots clean and free from obstructions. If available, blow compressed
air into the vents to clear any internal dust (safety goggles must be worn when undertaking this
process).
2. Never use water or chemical cleaners to clean your power tool. Wipe clean with a dry cloth.
3. Your power tool requires no additional lubrication.
4. Always store your power tool in a dry place.
5. If you see some sparks flashing in the ventilation slots, this is normal and will not damage your power
tool.
6. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
TROUBLESHOOTING
1. If your power tool will not operate, check the power at the mains plug, or check the carbon brushes.
11