6
IMPORTANT SAFETY INSTRUCTIONS
WARNING
To reduce the risk of fire, electrical shock,
or injury when using your appliance, follow
these basic precautions:
Read all instructions before using the appliance.
DANGER or WARNING:
An empty cooler can be a hazardous for children or small pets.
If disposing of the cooler, remove gasket seals, latches, lids or the entire door from your
unused appliance, or take other action to ensure the cooler is harmless.
Never allow children to operate, play with, or crawl inside the appliance.
Never clean appliance parts with flammable fluids or harsh chemicals. The fumes can create
a fire hazard or explosion.
Do not store or use gasoline or any other flammable vapors and liquids in the vicinity of this or
any other appliance. The fumes can create a fire hazard or explosion.
INSTALLATION INSTRUCTIONS
BEFORE USING YOUR APPLIANCE
Remove the exterior and interior packing.
Before connecting the appliance to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
Clean the interior surface with lukewarm water using a soft cloth.
Install the handle on the door.
INSTALLATION OF YOUR APPLIANCE
This
appliance is designed to be free standing only, and should not be recessed or built-in.
WARNING
: Do not store or install the appliance outdoors.
CAUTION
:
This appliance is designed for storing and cooling beverage or wines. Do not
store perishable food, medicine or other medical products.
Place your appliance on a hard and level floor that is strong enough to support it when it is
fully loaded.
Allow at least 5 inches (127mm) of space between the back and sides of the appliance are
suggested, which allows the proper air circulation to cool the compressor and condenser.
It is recommended that you do not install the appliance on carpet.
To level your appliance, adjust the front leveling leg at the bottom of the appliance if needed.
It is recommended that you do not install the appliance near an oven, radiator or other
heating source. Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption. For best performance, do not install the appliance behind a cabinet
door or block the base grille. Extreme cold ambient temperatures may also cause the
appliance not to perform properly.
Avoid locating the appliance in area that may be exposed to excessive moisture.
Plug in the appliance into an exclusive, properly installed-grounded wall power outlet. Do not
under any circumstances cut or remove the third (ground) prong from the power cord. Any
questions concerning power and/or grounding should be directed toward a qualified
electrician or an authorized service center. After plugging the appliance into a wall outlet,
allow it to cool down for 2-3 hours before placing beverages in the appliance.