6
Installation Instructions
Before Using Your Wine Cooler
Remove all exterior and interior packing.
Clean the interior surface with lukewarm water
using a soft cloth.
The door on this appliance can be opened from
either the left or the right side. The unit is
delivered with the door opening on the left side.
Should you wish to open the door from the right,
follow the instructions „Reversing the door swing
of your appliance‟.
Installation of Your Wine Cooler
The appliance is designed to be built in between
kitchen cabinets and is supplied with adjustable
feet that can be altered to fit various worktop
heights. This wine cooler is fully compatible with
any 600mm deep kitchen unit.
Place your Wine Cooler on a floor that is strong
enough to support it when it is fully loaded. To
level your Wine Cooler, adjust the leveling leg at
the bottom of the Wine Cooler.
Locate the Wine Cooler away from direct
sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the
acrylic coating and heat sources may increase
electrical consumption. Extreme cold ambient
temperatures may also cause the unit not to
perform properly.
Avoid locating the unit in damp areas.
Plug the Wine Cooler into an exclusive, easily
accessible plug socket. Any questions
concerning power and/or earthing should be
directed towards a qualified electrician or an
authorized products service centre.
The air vent at the front of the appliance must
never be covered or blocked in any way.
The appliance must be installed to all electrical,
plumbing, water and drain connections in
accordance with state and local codes.
